In situ thermal diagnotics of the micro-PCR system using liquid crystals

Abstract

A simple, reliable liquid crystal (LC) thermometry of a polymerase chain reaction (PCR) chip that has a microchamber inside the chip and a film heater and a film sensor patterned on the surface is firstly introduced. The silicon-based PCR chip is made by MEMS technology. A non-linear feedback proportional-integral control scheme adjusts the power input of the Pt heater to control the surface temperature of the micro-PCR chip measured by the Pt sensor with an accuracy of less than ±0.1 °C at steady state. We use the LC thermometry to analyze the temperature distribution in the microchamber of the micro-PCR chip. The reflected colors of LC's inside the microchamber are captured through a charge-coupled device (CCD) camera, subsequently analyzed using a hue-based color analysis system. Two LC's of which individual working range is near the typical PCR temperature of 55 °C and 72 °C are calibrated in a constant temperature bath with a resolution of less than ±0.3 °C. While the average microchamber temperature near the annealing temperature is similar to the surface temperature, it is lower than the surface temperature by ca. 1 °C in the range of the extension temperature. Also, the temperature variations along the center of the microchamber, are less than 1.5 ± 0.5 °C and 3 ± 0.3 °C in the range of the annealing and the extension temperature, respectively.