DC Field | Value | Language |
---|---|---|
dc.contributor.author | 심도식 | - |
dc.contributor.author | 윤석준 | - |
dc.contributor.author | 이석렬 | - |
dc.contributor.author | 성대용 | - |
dc.contributor.author | 한용섭 | - |
dc.contributor.author | 한명수 | - |
dc.contributor.author | 양동열 | - |
dc.date.accessioned | 2013-03-18T20:00:10Z | - |
dc.date.available | 2013-03-18T20:00:10Z | - |
dc.date.created | 2012-02-06 | - |
dc.date.issued | 2005 | - |
dc.identifier.citation | 한국소성가공학회 2005년도 추계학술대회, v.0, no.0, pp.322 - 325 | - |
dc.identifier.uri | http://hdl.handle.net/10203/151947 | - |
dc.description.abstract | In order to make a doubly-cowed sheet metal effectively, the sheet metal forming process has been developed by adopting the flexibility of the incremental forming process and the principle of bending deformation which causes slight deformation in thickness. The developed process is an unconstrained forming process without holder. The experimental equipment has been set up with the roll set which consists of two pairs of support rolls and one center roll. In order to analyze process parameters in the incremental roll forming process for the application to doubly curved ship hull plate, the orthogonal array is adopted. From the FEM results, among the process parameters, the distance between supporting rolls in pairs along the direction of one principal radius of curvature as well as the forming depth is shown to influence the generation of curvature in the same direction significantly. That is, the other distance between supporting rolls in pairs which are not located in the same direction of one principal radius of curvature, does not have an significant effect on the generation of the curvature in that direction. Also, the forming load and torque from the FEM simulation are acceptable to the system development of the incremental roll forming process for the forming of ship hull plate. | - |
dc.language | KOR | - |
dc.publisher | 한국소성가공학회 | - |
dc.title | 점진적 롤 성형 공정의 선박 곡가공 적용을 위한 공정 변수 분석 | - |
dc.title.alternative | Analysis of Process Parameters in the Incremental Roll Forming Process for the Application to Doubly Curved Ship Hull Plate | - |
dc.type | Conference | - |
dc.type.rims | CONF | - |
dc.citation.volume | 0 | - |
dc.citation.issue | 0 | - |
dc.citation.beginningpage | 322 | - |
dc.citation.endingpage | 325 | - |
dc.citation.publicationname | 한국소성가공학회 2005년도 추계학술대회 | - |
dc.identifier.conferencecountry | South Korea | - |
dc.identifier.conferencecountry | South Korea | - |
dc.contributor.localauthor | 양동열 | - |
dc.contributor.nonIdAuthor | 심도식 | - |
dc.contributor.nonIdAuthor | 윤석준 | - |
dc.contributor.nonIdAuthor | 이석렬 | - |
dc.contributor.nonIdAuthor | 성대용 | - |
dc.contributor.nonIdAuthor | 한용섭 | - |
dc.contributor.nonIdAuthor | 한명수 | - |
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.