Browse "School of Mechanical and Aerospace Engineering(기계항공공학부)" by Type Article

Showing results 11181 to 11200 of 15753

11181
The behavior of flame front with heating mechanisms in two entrained-bed coal reactors

Cho, HC; Park, JK; Shin, Hyun Dong, FUEL, v.78, no.8, pp.953 - 961, 1999-06

11182
The bending of an aluminum structural frame with a rubber pad

Kwon, HC; Im, Yong-Taek; Ji, DC; Rhee, MH, JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, v.113, no.1-3, pp.786 - 791, 2001-06

11183
The bending stiffness of shoes is beneficial to running energetics if it does not disturb the natural MTP joint flexion

Oh, Keonyoung; Park, Sukyung, JOURNAL OF BIOMECHANICS, v.53, pp.127 - 135, 2017-02

11184
The benefits of using instantaneous energy to monitor the transient state of the wire EDM process

Kwon, S; Yang, Min-Yang, INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, v.27, no.9-10, pp.930 - 938, 2006-02

11185
The catalytically supported combustor for lean mixtures

Seo, YS; Kang, SK; Shin, Hyun Dong, INTERNATIONAL JOURNAL OF ENERGY RESEARCH, v.23, no.8, pp.695 - 705, 1999-06

11186
The characteristics of bio-oil produced from the pyrolysis of three marine macroalgae

Bae, Yoon Ju; Ryu, Changkook; Jeon, Jong-Ki; Park, Junhong; Suh, Dong Jin; Suh, Young-Woong; Chang, Daejun; et al, BIORESOURCE TECHNOLOGY, v.102, no.3, pp.3512 - 3520, 2011-02

11187
The coalescence of supported gold nanoparticles induced by nanosecond laser irradiation

Pan, H.; Ko, Seung Hwan; Grigoropoulos, C. P., APPLIED PHYSICS A-MATERIALS SCIENCE PROCESSING, v.90, no.2, pp.247 - 253, 2008-02

11188
The combined Monte-Carlo and finite-volume method for radiation in a two-dimensional irregular geometry

Baek, Seung-Wook; Byun, DY; Kang, SJ, INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, v.43, no.13, pp.2337 - 2344, 2000-07

11189
The Combustion of Liquefied Petroleum Gas Stratified and Homogeneous Charge Compression Ignition Engine

Bae, Choongsik; Yeom, K.T., FUELS -INTERNATIONAL COLLOQUIUM, v.6, pp.28 - 28, 2007-01

11190
The combustion of simulated waste particles in a fixed bed

Shin, D; Choi, Sangmin, COMBUSTION AND FLAME, v.121, no.1-2, pp.167 - 180, 2000-04

11191
THE COMPLEX ENVELOPE SIGNAL AND AN APPLICATION TO STRUCTURAL MODAL PARAMETER ESTIMATION

Park, Youn-sik; Lee, Jae-Kab, MECHANICAL SYSTEMS AND SIGNAL PROCESSING, v.8, no.2, pp.129 - 144, 1994-03

11192
THE COOLING OF A HEAT-GENERATING BOARD INSIDE A PARALLEL-PLATE CHANNEL

BEJAN, A; MOREGA, AM; LEE, SW; Kim, SungJin, INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW, v.14, no.2, pp.170 - 176, 1993-06

11193
The Cooling of Stacks of Plates Shielded by Porous Screens

Kim, SungJin, INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW, v.16, no.0, pp.16 - 24, 1995-05

11194
The current density and temperature distributions of anode-supported flat-tube solid oxide fuel cells affected by various channel designs

Park, Joon-Guen; Bae, Joong-Myeon; Kim, Jae-Yuk, INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, v.36, no.16, pp.9936 - 9944, 2011-08

11195
The Curved Wall Jet over a Circular Cylinder before the Interaction of Two Opposing Curved Wall Jets

Rew, H.S.; Park, Seung O., 대한기계학회논문집 A, v.10, no.1, pp.86 - 93, 1996-01

11196
The Cyclic Plastic Strain and Cumulative Fatigue Damage Under Actual Loading(Critical Modified S-N Curve in the Region below the Fatigue Limit)

m.kikukawa; m.joo; Song, Ji Ho, JOURNAL OF THE SOCIETY OF MATERIALS SCIENCE, v.23, no.252, pp.743 - 750, 1974

11197
The Cyclic Plastic Strain and Cumulative Fatigue Damage(Fatigue Damage Caused By the Stresses below the Fatigue Limit)

m.kikukawa; m.jono; Song, Ji Ho, JOURNAL OF THE SOCIETY OF MATERIALS SCIENCE, v.21, no.227, pp.753 - 758, 1972

11198
The design of a control coupled observer for the longitudinal control of autonomous vehicles

Choi, Seibum B, JOURNAL OF DYNAMIC SYSTEMS MEASUREMENT AND CONTROL-TRANSACTIONS OF THE ASME, v.120, no.2, pp.288 - 289, 1998-06

11199
The design of a look-down feedback adaptive controller for the lateral control of front-wheel-steering autonomous highway vehicles

Choi, Seibum B, IEEE TRANSACTIONS ON VEHICULAR TECHNOLOGY, v.49, no.6, pp.2257 - 2269, 2000-11

11200
The design of an optical sensor arrangement for the detection of oil contamination in an adhesively bonded structure of a liquefied natural gas (LNG) ship

Kim, BG; Lee, Dai Gil, MEASUREMENT SCIENCE & TECHNOLOGY, v.20, no.6, 2009-06

rss_1.0 rss_2.0 atom_1.0