Assembly of SnO2 Rod using Optical Tweezers and Laser Curing of Metal Nanoparticles

Cited 0 time in webofscience Cited 0 time in scopus
  • Hit : 810
  • Download : 28
Acicular tin dioxide (SnO2) rods (1–2 µm in diameter, 5–20 µm long) were assembled and fused on the patterned gold electrode by an optical tweezer. In addition, the electrical contact between the assembled SnO2 rod and the gold electrode was improved by laser curing of gold nanoparticles and the subsequent sintering in the oven. Here, the nanoparticles covered the entire area of the assembled SnO2 rod by evaporating a droplet of nanoparticle solution dripped on the assembled SnO2 rod. Subsequently, nanoparticles near the contact area between the rod and electrode were locally cured by direct heating with a focused infrared laser beam, which induced desorption of the surface monolayer. Therefore, the cured gold nanoparticles could be sintered after the non-laser irradiated nanoparticles were cleaned by the initial solvent application. Without sintering of the nanoparticles, the resistance of the assembled SnO2 rod was measured over several MΩ. After the nanoparticle sintering it could be reduced to a few hundred kΩ, which was in agreement with the resistance of the assembled SnO2 rod.
Publisher
Japan Society of Applied Physics
Issue Date
2010-05-20
Keywords

optical tweezer; nanoparticle; selective laser pricessing; SnO2 rod; laser curing

Citation

Japanese Journal of Applied Physics, Vol.49, pp.05EA12

ISSN
1347-4065
DOI
10.1143/JJAP.49.05EA12
URI
http://hdl.handle.net/10203/18929
Appears in Collection
ME-Journal Papers(저널논문)

qr_code

  • mendeley

    citeulike


rss_1.0 rss_2.0 atom_1.0